9/22/19
(Above: Jacobhouse’s closet-wall fully enclosed.)
Building Summary: This morning began with my fastening on the wheel to the base of the closet-wall’s slide out (used some spare flooring as spacing between the wheel and the undermount). After that, I obtained aluminum angle-stock from Container #2 along with measuring / cutting / fastening supplies* and brought them all over to the haybarn where the new makeshift worktable has been placed. This was followed by my helping Padre with a hefty bit of heifer activities.
The morning’s second portion ensued where I set about trimming the closet-wall’s face plate. This included measuring 1″ trim**, laying it along the face-plate’s length, and then drilling it / riveting it one hole at a time (so it could follow the plywood’s admittedly warped contours). After completing all sides like this, I took the finely-fitted plank out to Jacobhouse via Segway where Padre proceeded to help me place it in front of the closet-wall’s slide-out.
Fastening took some time. I first had to ensure that it was lifted up enough off the floor. Padre and I had placed it on the sizeable kneeling pad*** which was actually at just about the right height. I next had to ensure it was level / even along both sides – a task requiring use of a level, measuring tape, clamps, and a 2×4. Eventually, I was able to screw it into place, and after having done so, I tested the slide-out, as can be seen in the video just below.
TIL: Today I learned that one can grill carrots (Madre’s idea). I already figured it was possible, but what I did not know was how delectable they would be. After about 8-10 minutes on the grill, they had a pleasantly blackened exterior and a firm, yet not-crunchy interior. The spices I used were salt, red pepper, and a slight amount of garlic powder.
Commentary: The closet-wall’s foremost portion is now fully enclosed, and to add to this, the slide-out operates with exceptional smoothness. I am glad I installed the wheel on the front, for the face-plate – a fabrication comprised of aluminum angle-stock and ¾” plywood – is very heavy. However, it should also be noted that the heaviness also lends a sense of durability to the entire contrivance. Now, I believe all I need for the inside is a hanging rack for shirts, and some bins for lower-body garments.
As with the rest of Jacobhouse, it has been gratifying to see the closet-wall idea come to life.
Final Note: Tomorrow I plan on adding aluminum angle-stock to the sides of the other cupboard doors. This may be ensued by some trim-work in Jacobhouse and by my attaching those finished cupboard doors to their intended locations.
*Measure tape, hack saw, and drill / rivets / rivet gun.
** Originally began with ¾” trim, but it turned out to be too small to cover the face-plate’s warped / scarred edges.
*** An old seat cushion.